fot
[Top] [All Lists]
<prev [Date] next>
[Advanced]
 <prev [Thread] next>

distributor shaft bushing question

from [BOB KRAMER] [Permanent Link][Original]
To: "Triumphs List" <triumphs@autox.team.net>
Subject: distributor shaft bushing question
From: "BOB KRAMER" <rkramer3@austin.rr.com>
Date: Thu, 11 Dec 2003 14:04:17 -0600 
Does anyone know if it is possible to press in a distributor shaft bushing
into a TR6 block after the camshaft is installed, or does it foul on the
camshaft drive gear? I traded for a TR6 short block with new block and the
bushing is not installed in the block.
Bob Kramer
rkramer3@austin.rr.com
[More with this subject...]
<Prev in Thread] Current Thread [Next in Thread>
  • distributor shaft bushing question, BOB KRAMER <=
Previous by Date:  Original TR3/4 Thermostat-160 Degrees, N197TR4
Next by Date:  Nomination, Ed Diehl
Previous by Thread:  Original TR3/4 Thermostat-160 Degrees, N197TR4
Next by Thread:  Nomination, Ed Diehl
Indexes:  [Date] [Thread] [Top] [All Lists]