fot
[Top] [All Lists]

RE: Was TR Drag Race times, now Hot Rods in general

To: <FOT@autox.team.net>
Subject: RE: Was TR Drag Race times, now Hot Rods in general
From: "Barr, Scott" <sbarr@mccarty-law.com>
Date: Wed, 28 Jan 2004 11:05:37 -0600
Speaking of hot rods embarrassing the finer stuff, has anyone else read Brock 
Yates' (2003) book "The Hot Rod"?  I'm in the middle of it now and really 
enjoying it.  I keep thinking about that 289 Hi-Po snoozing in the corner Tom 
Strange's garage.  And that spare GT6 frame and body in my storage unit...  And 
then I have to remind myself that my new Spitfire racer is only 75% complete...

Must focus....

Scott  




-----Original Message-----
From: BillDentin@aol.com [mailto:BillDentin@aol.com]
Sent: Wednesday, January 28, 2004 10:03 AM
To: BFEKENG@aol.com; FOT@autox.team.net
Subject: Re: TR Drag Race times


In a message dated 01/28/2004 9:25:23 AM Central Standard Time, 
BFEKENG@aol.com writes:


> In the 50's They didnt know what to do with the TR's
> & they had to race with every thing on them, tops side curtains
> et al. By the mid 60's I was running in the 12.80's about
> 108 MPH with one or two runs at 12.50 & 110 mph.
> I would think a good vintage racer would be a low 13.00
> second machine & about 100 mph.
> 

To put that in perspective, in the 1950s John Reimer (Caledonia Automotive 
Service) an old Hot Rodder who went on to greatness in both road and circle 
track racing, built an MG-T with a Corvette engine to go road racing against 
Augie 
Pabst.  The car went great, but wouldn't stop or turn, so he took it Drag 
Racing.  His best times were similar to Ken's TR2 mentioned above.  Those 
elapsed 
times sound slow by today's standards, but in the 1950s...that was FLYING.  
KUDOS to Ken and his crew in the little four banger.  Retired now, in the 1990s 
Reimer restored his MG-T, added some modern brakes, rubber, and a custom 
intake manifold with six carbs.  He ran the car often at ROAD AMERICA.  It was 
a 
hoot to watch him embarrass cars like the Scarab, LOTUS 23B, etc., etc.

Bill Dentinger

<Prev in Thread] Current Thread [Next in Thread>