fot
[Top] [All Lists]

More on rings

To: <fot@autox.team.net>
Subject: More on rings
From: "kas kastner" <kaskas@cox.net>
Date: Tue, 10 Feb 2004 08:55:26 -0800
Yes, the same technique will work with a dry block as I did on the TR-4
sleeves. And yes, you can use Comet or Ajax (or like stuff) with equal
results. You need to do a very very through job of cleaning if you lap into a
dry block 'cause the cleanser will not be friendly to bearings and smooth
surfaces.

 I found that the chrome rings were almost impossible to seat if you did the
usual break-in at slow running and low revs.  They would pass pressure and
oil forever.  What I found that worked every time, operate the engine at low
speed for a bit, like three or four minutes, then take it out and run the
devil right out of it for a couple laps.  The chrome rings seem to like this
abuse and they sealed up immediately. The slow running on the chrome seemed to
glaze the cylinder walls and never let a full seat occur.  Yup, that's my
opinion.

"Never be beaten by Equipment"
Kas Kastner

<Prev in Thread] Current Thread [Next in Thread>