fot
[Top] [All Lists]

Re: [FOT] Clutch Slave Cylinder - Herald

To: <Cwn74@aol.com>, <billsohl@mindspring.com>, <fot@autox.team.net>
Subject: Re: [FOT] Clutch Slave Cylinder - Herald
From: "Rocky Entriken" <rocky@tri.net>
Date: Wed, 9 Aug 2006 15:56:47 -0500
I'll keep an eye (foot?) on that. Ran the car last weekend. I did notice the
pedal seemed low at first pump, but after that it was fine all day. And the
clutch worked again!

--Rocky
  ----- Original Message -----
  From: Cwn74@aol.com
  To: rocky@tri.net ; billsohl@mindspring.com ; fot@autox.team.net
  Sent: Wednesday, August 09, 2006 3:25 PM
  Subject: Re: [FOT] Clutch Slave Cylinder - Herald


  I hope you know that if you rotate the bleeder to the bottom, the air goes
to the top and will not bleed out the relocated bleeder......

  Anyway, I installed a Speedbleeder (often discussed on these forums, you may
want the sp3824L part www.speedbleeder.com) on my Spitfire clutch slave and
thus it is much easier 1 person job.  Open the bleeder, pump a bunch and
refill the master when needed.  Tighten the bleeder and you're done. A short
combo wrench or 1/4" drive ratchet with extension and perhaps a universal to
open and close.  A piece of tubing to direct the blood to a catching
device....

  Good luck!
  Clark


  In a message dated 8/9/2006 4:01:34 P.M. Eastern Daylight Time,
rocky@tri.net writes:
    Yeah, you gotta pull the tranny cover.

    Not sure about Herald, but not a big deal in the Spitfire.

    I just replaced my clutch slave. Rather than rebuild the old one I just
    bought a new one .. <$90. And there was a difference!

    The old one has a groove along one side where the clamp screw goes, so it
    only goes in one way (bleed screw on top). The new one that came has the
    groove all the way around, so I installed it upside down with the bleed
    screw at the bottom, so that I *can* bleed it from under the car if need
be.

    --Rocky Entriken

    ----- Original Message -----
    From: "Bill Sohl" <billsohl@mindspring.com>
    To: "FOT" <fot@autox.team.net>
    Sent: Tuesday, August 08, 2006 8:50 PM
    Subject: [FOT] Clutch Slave Cylinder - Herald


    > OK folks, any words of guidance on how to
    > actually get at the clutch slave cylinder in a
    > Herald to
    > (1) bleed the line and/or to
    > (2) remove and replace a slave cylinder?
    >
    > My factory manual applies the same steps for
    > Herald and Spitfires.
    >
    > My "let's see how the access is" from under
    > the car sez no way without removing the transmission
    > cover...unless you have mini-arms, hands and fingers.
    >
    > Cheers,
    > Bill Sohl
    >

  Clark

  74 Spitfire, 71 Stag
  "Reality... it's not what you think"
  Clark W. Nicholls
  CWNicholls@aol.com
  www.cwnicholls.com
  fax: 419-844-7564 (yes, 419 provided free by efax.com)
  phone: 413-243-3433



<Prev in Thread] Current Thread [Next in Thread>