I did it.
http://www.gt6.ca/08/0108/index.html
http://www.gt6.ca/08/0223/index.html
http://www.gt6.ca/08/0310/index.html
http://www.gt6.ca/08/0405/index.html
http://www.gt6.ca/08/0614/index.html
Questions :) ?
A.
On 14-Sep-08, at 3:02 PM, Chris Kantarjiev wrote:
> After years of pushing the parts around my shop, I'm finally
> getting started on this project. The mounting adapter plates
> were easy enough. Now I'm to the point where I want to open
> up the intake manifold to match them.
>
> Unfortunately, there isn't enough meat in the manifold to just
> open the hole to 1.5" all the way in to where the runners
> split off; doing that will come out into the open air :-(
> My normal inclination would be to just grind it out by hand,
> but it occurs to me that I might be better off doing this
> with a boring head on the mill and then doing the final
> smoothing by hand.
>
> I'd be really interested to hear suggestions about how these
> holes should be shaped to make the most of the mod... Kas? Anyone?
>
> Thanks,
> chris
> _______________________________________________
> http://www.team.net/donate.html
>
> Fot mailing list
> Fot@autox.team.net
> http://autox.team.net/mailman/listinfo/fot
>
--
Andre Rousseau - andre@gt6.ca
'68 Triumph GT6 MK1 - http://www.gt6.ca/
Ottawa, ON, Canada
_______________________________________________
http://www.team.net/donate.html
Fot mailing list
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot
|