On Tue, 31 Mar 2009, MadMarx wrote:
> After I got 5 wheels for my TR 4 I now would like to know what torque the
> nuts need?
> Any suggestions?
If you have the wheels hub centric, then 65 ft/lb should be adequate.
If your wheels are not hub centric, then you can set to 65 but after you
drive half a mile or so, re-torque to 65 or 70 as they will work loose.
My wheels were bored to 3" and I use spacers that do not have a locating
lug - and the lugnuts used to work loose as described above.
> THX
>
> Chris
regards,
rml
---------------------------------------------------------------------------
Bob Lang NER/SCCA | This space for rent
Solo Chair 2008 TR6 40 F Prepared | Triumph!
Voice:781-438-2568 FAX: 617-258-9535 | Cell: 339-927-4489
---------------------------------------------------------------------------
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.fot-racing.com
Fot mailing list
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot
|