fot
[Top] [All Lists]

Re: [Fot] SPAM-LOW: Spitfire Flywheel Bolts

To: <robert@mackenzie.aero>, <fot@autox.team.net>
Subject: Re: [Fot] SPAM-LOW: Spitfire Flywheel Bolts
From: "Charly Mitchel" <charly@mitchelplumbing.com>
Date: Wed, 26 May 2010 07:46:16 -0700
I use the ARP bolts for a 350 Chevy for my TR6.  I believe they are the same 
as Spits.
I did break the heads off of 3 out of 4 one time but have had no problems 
since then.
Charly Mitchel
TR6 #44
----- Original Message ----- 
From: "Robert MacKenzie" <list@mackenzie.aero>
To: <fot@autox.team.net>
Sent: Tuesday, May 25, 2010 8:06 PM
Subject: SPAM-LOW: [Fot] Spitfire Flywheel Bolts


>I have been building up a performance 1500 engine for my '79 Spitfire
> street/autocross car.
> Starting with a early 1500 block with flat-top pistons, I had  all the
> spinning bits dynamically balanced and installed one of Ted's 275-4 cams.
> 9:1 CR topped off with  a ported head with custom bee-hive valve springs 
> by
> Costa Mesa R&D.  All in all a solid but not over the top spec looking more
> towards reliability and drivability over outright performance.
> One choice I made was to stick with a stock flywheel.  When I installed it 
> I
> used new bolts from a reputable specialist vendor.  I have heard that one
> should not re-use the original bolts and I have also read the ARP bolts 
> are
> higher in shear strength but tend to be brittle and break.
> The engine ran fine on first start but after a 45 min run-in the first 
> time
> I opened the throttle and brought it up to some serious RPM (5500 +) the
> flywheel bolts failed.
>
> Questions:
> What is everybody else using in their full race motors?
> Could this just be a bad bolt or two?
> What are your thoughts on APR vs stock hardware?
>
> Robert MacKenzie
> NASS # 511
> Austin Texas
> '79 1500 (street)
> '62 Spitfire 4 (race)
> _______________________________________________
> fot@autox.team.net
>
> http://www.fot-racing.com
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe: 
> http://autox.team.net/mailman/options/fot/charly@mitchelplumbing.com
_______________________________________________
fot@autox.team.net

http://www.fot-racing.com

Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums


<Prev in Thread] Current Thread [Next in Thread>
  • Re: [Fot] SPAM-LOW: Spitfire Flywheel Bolts, Charly Mitchel <=