fot
[Top] [All Lists]

Re: [Fot] Stocker questions

To: <fot@autox.team.net>
Subject: Re: [Fot] Stocker questions
From: "Jack Brooks" <jibjib@att.net>
Date: Fri, 8 Oct 2010 14:41:48 -0700
TerriAnn nailed it all except the brakes, which seems really weird to me.
Do you have a stock caliper to compare the Wilwoods to?  I can't think of
anything that would put the caliper out an inch from the C/L of the wheel.

Jack

-----Original Message-----
From: fot-bounces@autox.team.net [mailto:fot-bounces@autox.team.net] On
Behalf Of TeriAnn J. Wakeman
Sent: Friday, October 08, 2010 12:44 PM
To: fot@autox.team.net
Subject: Re: [Fot] Stocker questions

On 10/8/10 12:01 PM, Bill Babcock wrote:
> Trans mounts--I'm using the OD trans from the Ambro. Looks like the
> transmission mount is a little aft of normal, though I haven't stuck a
mount
> in there yet to check. Anything special needed? I assume I need a shorter
> driveshaft. Yes/No?
>    

Hi Bill, you didn't mention which bellhousing and which gearbox you 
have, so I'll go worst case of a TR4 gearbox into a TR3 frame & bellhousing:

The TR4 Transmission will bolt up to a TR3 bell housing . You will need 
the next length longer bolts at the bottom of the bell housing because 
the lip on the TR4 transmission is wider then on the TR3 transmission. 
This will also require you to readjust the clutch slave cylinder rod.

The transmission mounting holes will be slightly to the rear of the 
cross member mounting holes. This can be corrected by elongating the 
mounting holes on the bracket where it mounts to the transmission and 
where the bracket mounts to the frame.

You can use a TR3 drive shaft without modifications. By the way, the 
transmission goes in easier if the drive shaft is completely removed. 
Otherwise it gets in the way of lining up the transmission for 
installation. Since the TR4 shift lever is different, use the TR3 shift 
lever. It is a direct fit.

> I'm using the Moss rack conversion. Seems like the geometry is pretty
good. I
> decided not to cobble together something (NO, I'm not using a TR3 worm and
> pin--yuck). Anyone have any experience with this? So far, so good.
>    

My TR3 got that exact conversion last July.  I love it!!!!  Steers a lot 
better with a lot less effort.   I would never go back.

Teriann
_______________________________________________
fot@autox.team.net

http://www.fot-racing.com

Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe: http://autox.team.net/mailman/options/fot/jibjib@att.net
_______________________________________________
fot@autox.team.net

http://www.fot-racing.com

Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums


<Prev in Thread] Current Thread [Next in Thread>