Mike, there is an O-ring on the outer periphery of the bearing. The O-ring may
be cut and leaking or missing? These are also sealed bearings. You may have
had a seal failure, in which case you would need to replace the bearing. This
is Moser part number 9507F. Joe(B)
---------- Original Message ----------
From: Mike Mehl <mike.mehl@yahoo.com>
To: Triumph Friends of <fot@autox.team.net>
Subject: [Fot] Southwick axle pushing out gear oil from Right Rear (TR4)
Date: Sun, 10 Jul 2011 20:59:35 -0700 (PDT)
My axle (just over a year and about 6 race hours old) is pushing oil out
through end of the axle - right side. The left rear is dry as a bone. Has
anyone else had this type of issue? If so how did you fix it.
Mike Mehl #46
The good news is I have run the car three race weekend with normal problems
(not spun bearings).
Thanks!!!!!!!
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe: http://autox.team.net/mailman/options/fot/jaboruch@netzero.net
____________________________________________________________
57 Year Old Mom Looks 27!
Mom Reveals $5 Wrinkle Trick That Has Angered Doctors!
http://thirdpartyoffers.netzero.net/TGL3231/4e1b008f1c4293397cdst06duc
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|