Removed the HS2's from the Spitfire and replacing them with HS4's for the
Mitty so I will have the opportunity to try and dial in something else that
weekend. Fired the engine up for the first time saturday so I am getting
closer. Anyhow, on the HS4's, the rear car has a 1/4 o.d. stub of a hard line
coming out for the vent/overflow of the bowl. The front carb just has a hole
for the vent/overflow. The hole does not appear to match any line I have
laying around. Smaller than 1/4, larger than the next size down copper line
and hard brake lines I have. I though about opening it up to 1/4 but then
there would not be enough room to slip on a piece of rubber fuel line. I am
trying to run these overflows away from the header. What have you folks done
here on the front carb?
Thanks,
Marty
PS: Hope everybody has paid Ted for the shirts by now.
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe:
http://autox.team.net/mailman/options/fot/fot-archive@autox.team.net
|