fot
[Top] [All Lists]

[Healeys] Belleville washers in BN2 steering box

Subject: [Healeys] Belleville washers in BN2 steering box
From: obrimberry at hunterbane.com (Olin Brimberry)
Date: Tue, 10 Jan 2017 17:14:59 -0500
References: <5c4d20a5-d2ec-b119-8b67-e3a3923683eb@comcast.net>
Bob,

I figured height of the spring was also important, so I put 2 together and 
measured the height with calipers
Height of 2 washers: 0.100 inches
Height of 1 washer: 0.050 inches
Thickness of washer: 0.025 inches
Checking the previous diameter dimensions with a caliper, I get:
 
ID: 1.057 inches
OD: 1.5 inches

I suspect that the ID is originally spec'd to be 1-1/16" but because of the 
slight "spring", the diameter is slightly less.  Good luck

Olin K. Brimberry, PE
Principal Engineer
obrimberry at hunterbane.com
Office - 919.803.4274
Mobile - 919.522.1608

HunterBane Engineering, PLLC
PO Box 10314
Raleigh, NC 27605
3306 Alamance Drive
Raleigh, NC 27609



-----Original Message-----
From: Olin Brimberry [mailto:obrimberry at hunterbane.com] 
Sent: Tuesday, January 10, 2017 4:34 PM
To: 'Bob Spidell' <bspidell at comcast.net>; 'Healeys' <healeys at 
autox.team.net>
Subject: RE: [Healeys] Belleville washers in BN2 steering box

I just pulled mine out of a steering box I am rebuilding, and yes there are 6 
positioned as such: ()()() Where only the outer edges touch.  The dimensions 
are as follows:

ID: 1-1/16
OD: 1-1/2
Pictures of the measurements are attached for verification purposes.

The washers were loose on the shaft, but I think the closer tolerance is going 
to be on the OD side.

Olin K. Brimberry, PE
Principal Engineer
obrimberry at hunterbane.com
Office - 919.803.4274
Mobile - 919.522.1608

HunterBane Engineering, PLLC
PO Box 10314
Raleigh, NC 27605
3306 Alamance Drive
Raleigh, NC 27609


-----Original Message-----
From: Bob Spidell [mailto:bspidell at comcast.net] 
Sent: Monday, January 9, 2017 5:48 PM
To: Healeys <healeys at autox.team.net>
Subject: [Healeys] Belleville washers in BN2 steering box

The Moss catalog calls for 6 'belleville' washers under the rocker shaft in the 
late BN, early BN4/6 steering box (Moss part# 725-115).  Mine doesn't appear to 
have ever had them; anyone know if they're required?  
I'm guessing yes, because otherwise the rocker shaft looks like it rests on a 
rough surface but, they list for $12.79/ea, and if they're not necessary--or if 
anyone knows of a cheaper alternative--I'd prefer not to spend that much.

TIA,

Bob




---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus


<Prev in Thread] Current Thread [Next in Thread>