--===============7588678193678001870==
--00000000000060a4b805c4f675b2
Hi all.
I am switching over to a newer set of webers on GT6 and would like to use
the choke tubes from the old carbs. Problem is there are no holes for the
idle air screws. Can I get away with just drilling new holes in the chokes
/ not worry about putting any holes in the chokes and don't use the idle
air adjust or Plan C ??
Thanks P.J.
--00000000000060a4b805c4f675b2
Content-Transfer-Encoding: quoted-printable
<div dir=3D"ltr">Hi all.<div>=C2=A0I am switching over to a newer set of we=
bers on GT6 and would like to use the choke tubes from the old carbs. Probl=
em is there are no holes for the idle air screws. Can I get away with just =
drilling new holes in the chokes / not worry about putting any holes in the=
chokes and don't use the idle air adjust or Plan C ??</div><div>=C2=A0=
=C2=A0 =C2=A0 =C2=A0 =C2=A0 =C2=A0 =C2=A0 =C2=A0 =C2=A0 =C2=A0 =C2=A0 =C2=
=A0 =C2=A0 =C2=A0 =C2=A0 =C2=A0 =C2=A0 =C2=A0 =C2=A0 =C2=A0Thanks P.J.</div=
></div>
--00000000000060a4b805c4f675b2--
--===============7588678193678001870==
Content-Transfer-Encoding: 7bit
Content-Disposition: inline
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Archive: http://autox.team.net/archive http://www.team.net/pipermail/fot
--===============7588678193678001870==--
|