Thanks for your response and good wishes.
On May 2, 2004, at 10:17 PM, Dave & Marlene wrote:
> Thanks for the update. I think I remember the problem but had no ideas.
> Don't know a thing about adjusting "the" switch. When you find out,
> let us know.
> Good luck on the project & have fun at Glenwood.
> Dave Russell
> BN2 without "the" switch
> Bill Lawrence wrote:
>> Some may recall about a year and a half ago I was asking if anyone
>> knew of a problem that could cause a vibration on the road when
>> operating only in overdrive. Well in preparation for another road
>> trip in June, yesterday I spent a pleasant afternoon pulling the
>> tranny out of the BN1 to see if I could get to the bottom of the
>> I have been running with my centrifugal switch jumped out for the
>> last two years and have just recently decided to check its operation.
>> It seems to work, but is nowhere near its designed set points coming
>> in at about 20 MPH and dropping out at about 5 MPH. Can anyone tell
>> me how these are supposed to be adjusted? There are two screws on the
>> Off to Glenwood June 11-13.
>> Bill Lawrence