healeys
[Top] [All Lists]

Re: Rust prevention/coating product

To: tomfelts@earthlink.net, healeys@autox.team.net
Subject: Re: Rust prevention/coating product
From: tammie wall <whammie@iopener.net>
Date: Thu, 31 Mar 2005 16:26:18 -0600
tom,
is the bedliner in lieu of carpets ?
cheers,
jerry
tom felts wrote:
 > 
 > I just finished some floor repair on my E-Type and then covered it with the
 > black truck bed liner stuff.  It sets up quickly and seals and look nice.
 > I'll bet it is a little cheaper that these products.  I had never heard of
 > anyone using it for this, but if it withstands stuff being tossed and slid
 > around in a truck bed it can't be all bad.
 > 
 > tom
 > 
 > 
 > 
 > 
 > > [Original Message]
 > > From: Charlie Baldwin <ewsinc@suscom.net>
 > > To: Malaney, David W <DavidWMalaney@eaton.com>
 > > Cc: Healeys' (E-mail) <healeys@autox.team.net>
 > > Date: 3/31/05 4:49:01 PM
 > > Subject: Re: Rust prevention/coating product
 > >
 > > Before this product existed, I used to see the owner of this company
 > > selling POR 15 at Carlisle and Hershey, PA flea market events.  Of
 > > course then, his line was that nothing was better than POR 15.  He then
 > > "developed" his own product which is naturally better than the
 > > competition.  I bought some of his once.  Can't say I had any problems
 > > with it, except that it dried up in the can, which POR does also.  POR
 > > now has tiny litle cans in a six pack which takes car of that problem.
 > > I don't know if this guy has those or not.
 > > I suspect that both products are very similar.  BTW, POR has a neat
 > > epoxy putty that works great for filling in pitted areas or building up
 > > areas where you want something stronger than body putty.  After it is
 > > dry, it is workable, but a grinder works better than sandpaper.  I know
 > > that it is sometimes less expensive to buy POR from one of their dealers
 > > than from the factory, perhaps that is the case with Mastercoat also.
 > > Check the internet for best prices on either and for their full line of
 > > products.
 > > Charlie
 > > owner of rusty parts for many years
 > >
 > > Malaney, David W wrote:
 > >
 > > >Anyone familiar with this product?  www  nomorerust  com
 > > >They say it has a 'leveling the heavy pitting' aspect to it.  That could
 > be
 > > >good for a lot of old, pitted parts.   Plus they have hi heat ceramic
 > > >coatings.
 > > >
 > > >usual disclaimers apply
 > > >
 > > >
 > > >Dave M.
 > 
 > Your messages not reaching the list?




<Prev in Thread] Current Thread [Next in Thread>