Anyone know what the thread size is for the water pump studs into the
block? I am having a cast iron welding repair done to one of the holes
that was a welded in place bolt and a terrible prior weld repair. They
are going to re-weld the hole up. It will then need to be redrilled and
tapped for the bottom water pump stud. BTW - does anyone have 3 water
pump studs for a 4 cylinder block?
Mike MacLean
56 BN2
60 AN5
--
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.0.308 / Virus Database: 266.9.7 - Release Date: 4/12/2005
|