healeys
[Top] [All Lists]

RE: generator compatibility

To: "'Jonathan and Carole Quandt'" <fourqz@earthlink.net>,
Subject: RE: generator compatibility
From: "Michael Williams" <mewilliams@comcast.net>
Date: Sun, 24 Apr 2005 15:41:19 -0400
Jonathan,

When I bought my BN1 it had a generator for a later Healey, along with the
later pulley. I don't know how long it had been run that way before I got
it. I ran it that way another 3,000 miles or so before I started the
restoration. I never had any problems but I'm sure running with the
different width pulley would not be good in the long term. Since the later
pulley shaft is a smaller diameter than the one on the BN1/2, I think you
would have to do a narrow belt conversion and swap out *all* of the pulleys.
At that point, you are probably into the same (or more) money than the cost
of a proper 100 generator or even an alternator.

--Michael
'55 BN1

-----Original Message-----
From: owner-healeys@autox.team.net [mailto:owner-healeys@autox.team.net] On
Behalf Of Jonathan and Carole Quandt
Sent: Sunday, April 24, 2005 2:58 PM
To: healeys@autox.team.net
Subject: generator compatibility 

Can a generator for an AH 100-6 or 3000 be used on a 100-4? I can buy a 
rebuilt generator from the local auto parts store for a 100-6 for about 
$150. Any problems with pulley alignment or mounting points if you drop 
it in a 100-4 ? Thanx Jonathan




<Prev in Thread] Current Thread [Next in Thread>