| To: | "Healey Forum" <healeys@autox.team.net> |
|---|---|
| Subject: | Rear Axel Nut |
| From: | <glembotski@sbcglobal.net> |
| Date: | Mon, 2 May 2005 18:42:59 -0700 |
I have seen this discussed before but what size socket is required to remove the subject nut from a BJ8 axel? Also the manual describes the tool to reinstall the hub to the axle housing as a circular drift. It appears to be a length of steel tubing. Does anyone know the ID of the tubing required, and where some length of this can be obtained. Thanks in advance John G. 67 BJ8 |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: Steering wheel cover...Concours, Keith Pennell |
|---|---|
| Next by Date: | Re: Rear Axel Nut, Bob Haskell |
| Previous by Thread: | THE PALO ALTO BRITISH CAR MEET, September 10th & 11th, Richard Feibusch |
| Next by Thread: | Re: Rear Axel Nut, Bob Haskell |
| Indexes: | [Date] [Thread] [Top] [All Lists] |