You can not use the BJ8 style clutch on the BN1 transmisison, You must
use the BN1 clutch cover in the BN1 transmission. So the early 6
cylinder flywheel will work with the BN1 clutch cover.
David Nock
On Sep 22, 2005, at 7:01 PM, Laurie Wilford wrote:
>
> I planned on using a lightened BJ8 flywheel and diaphram pressure
> plate on my BN1. When I attempted to bolt the 3 speed bell housing on
> with this set-up, the flywheel proved too large. It hung up on the
> bell housing. I was told this would work with a BN2 but not a BN1. Did
> I miss something?
>
>
> Laurie Wilford
> BJ8, BT7, BN1
>
>
>
>
>
>> From: David Nock <healeydoc@sbcglobal.net>
>> Reply-To: David Nock <healeydoc@sbcglobal.net>
>> To: "David" <dcrawfor@san.rr.com>
>> CC: <KingR44916@aol.com>, <healeys@autox.team.net>
>> Subject: Re: lightened flywheel
>> Date: Thu, 22 Sep 2005 09:27:45 -0700
>>
>> The new 15 lb flywheels at $660.00 they will take either the spring
>> or the diaphgram cover.
>>
>> David Nock
>> British Car Specialists
>> Stockton Ca 95205
>> 209-948-8767
>>
>> www.britishcarspecialists.com
|