You need to apply air to the hole you drilled and see where the bubbles come
from . That's your leak.
Dean
> Jim: Many moons ago someone on The List stated that Ford Part #
> COAZ-9202-B was a suitable substitute. It was indicated that this was a
> brass float and cost about $4.00. As I said - many moons ago ..... I
> have
> not purchased one - yet - so I can't verify the facts.
>
> I just had the same problem this week. Drilled a small hole in the end,
> drained the gas out, soldered up the hole. Could not find any hole or
> crack that would have allowed the leak so I may only be good for a short
> while. THEN I may go visit my local Ford parts department.
>
> (The Other) Len
> Vacaville, CA
> 1967 3000 MKIII HBJ8L39031
|