Alan,
I don't doubt your words but IMHO this procedure is rather inexact. You could
easily be 5 degrees or more off each side of TDC.
Eric
www.brits-n-pieces.com
-----Urspr|ngliche Nachricht-----
Von: owner-healeys@autox.team.net
[mailto:owner-healeys@autox.team.net]Im Auftrag von Alan Seigrist Blue
100
Gesendet: Dienstag, 29. August 2006 12:15
An: Peter Linn
Cc: healeys@autox.team.net
Betreff: Re: BN1 timing marks
Peter -
If I'm not mistaken, you can determine TDC by watching the valves for
the opposing piston to #1 ... so, I think that means just before the intake
valve opens for #4 is TDC for #1. I did this once before and it was spot on
for TDC. This may be in the manual, I know you can do this for the 6 cyl
too.
Alan
'52 A90
'53 BN1
'64 BJ8
[demime 1.01d removed an attachment of type application/x-pkcs7-signature which
had a name of smime.p7s]
|