| To: | "Mr. Finespanner" <mrfinespanner@earthlink.net>, |
|---|---|
| Subject: | Re: rocker panels |
| From: | <pennell@cox.net> |
| Date: | Thu, 4 Jan 2007 18:14:18 -0500 |
Doug, Like you I have seen several of the recent repros of these and they are just as you say. Takes a bit of cutting, welding and grinding to make them right. At least they are not straight as they should have about 1/2 inch of fore to aft curvature. No knowledge of any other supplier though. Keith Pennell > Anyone know a source for rocker panels that fit right? The pair > I just got from AH Spares are half an inch too long on the outer > face. > Doug Reid, 18G Motorworks |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Stainless BJ8 Exhaust System, James Sailer |
|---|---|
| Next by Date: | BT7 Bearing - carrier - shim question, Michael Giroux |
| Previous by Thread: | rocker panels, Mr. Finespanner |
| Next by Thread: | Oil Pressure Gauge Vibration, Ned Smith |
| Indexes: | [Date] [Thread] [Top] [All Lists] |