Hello Patrick;
The Austin Healey Club of Southern Ontario web site contains a bulletin on
seat belts in early Sprites, 100-6 and 3000 roadsters in pdf format. It was
obtained from a series of BMC/BL technical and service bulletins; specifically,
from Austin Service Journal 1961-11-16 A437. It shows the anchor fittings
for both the driver and front passenger use. While not specific for the 100,
hopefully it will be of some help to your friend.
I have also attached the same material in an MSWord format.
http://www.ahcso.com/Tech%20Talk/Seat%20Belts/Seat%20Belt-ASJ.pdf
--Scott Morris [ '62 3000 MkII BT7-driver; '60 3000 MkI BN7-project]
Simcoe, Ontario, Canada
"Quinn, Patrick" <Patrick.Quinn@det.nsw.edu.au> wrote: << G'day
A friend has just bought a set of 3 point lap/sash seat belts for his 100 and
isn't quite sure where the belts should be attached to the car. Remember it's
a RHD car but I wouldn't have thought it should make any difference. As far as
the attachment near the seat bases perhaps the floor or the driveshaft tunnel
on one side and the floor on the other. With suitable backing plates of course.
However what about the third attachment for the belt so that it can easily go
over the shoulder? Perhaps the wheel arches would be best? Your thoughts would
be appreciated. >>
J. Scott Morris - Keep Smiling, Murphy Lives
---------------------------------
Yahoo! Canada Toolbar : Search from anywhere on the web and
bookmark your favourite sites. Download it now!
[demime 1.01d removed an attachment of type application/msword which had a name
of Seat Belt-ASJ.doc]
_______________________________________________
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|