Hi William,
Re: your item 4:
On BN1L-156610, the trunk lid support strut bolts through the wheel well wall
with two 1/4" diameter x 1"(+) hex head bolts (guessing 1-1/4" long), into the
trunk.
I'm not smart about thread forms, but the heads are in the wheel well, there is
a wooden spacer inside the trunk (on top of the carpeting) and the "Z-shaped"
bracket is then retained by lock nuts.
Attached is first of four annotated photos with "A, B, C" type dimensions. [The
photo will be stripped from the list].
I'll send the remaining three photos, dimensions and notes to you (only) in
three subsequent emails.
Please let me know if you have any questions.
Regards and Happy 2008.
Steve
----- Original Message ----
From: William Berg williamsantiks@hotmail.com
...
4. I replaced my inner wheel arch on the rear drivers side so, inside the
trunk, where exactly should the 2 holes be drilled that are used to bolt off
the trunk support. Are they on the wheel arch itself or on the box next to it.
Anyone have a picture?
Thanks for any help -William Berg '54 BN1
[demime 1.01d removed an attachment of type image/pjpeg which had a name of
UNKNOWN_PARAMETER_VALUE]
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|