healeys
[Top] [All Lists]

Re: [Healeys] Tall guy in a BJ8

To: "Bill Babcock" <BillB@bnj.com>, "Jack W. Drews"
Subject: Re: [Healeys] Tall guy in a BJ8
From: Bob Haskell <rchaskell@earthlink.net>
Date: Wed, 02 Jan 2008 06:33:54 -0500
Carl,

I'm 6' 9" and don't fit in the BJ8 or the 100 (darn).  I have a BT7 so this 
may not help too much.  I welded another piece of flat steel to the gearbox 
side of the seat bottom.  This allowed me to move the seat closer to the 
gearbox, about an inch.  That moved the seat back away from the wheel well 
enough so I could then move the seat back. I welded some additional flat 
stock onto the tabs the seat back mounts to tilt the seat back a bit. I 
then drilled a new set of holes in the seat frame for mounting to the slides.

For the "shorter" cushion, I used a new cushion (foam) from Heritage and 
drilled some blind holes on the bottom of the foam using a hole saw to 
soften the cushion - per Norm Nock's Tech book.  Question - anyone know how 
to seal the foam so little bits of foam stop falling on to the carpet?

I have a dished Moto-Lita wheel that came with the car.  Yes, it's a bad 
design in that it blocks the two small gauges, but the dish gives me more 
leg room. Does Mike Lempert make dished wheels? Mike?

Bob
'62 BT7
_______________________________________________
Support Team.Net http://www.team.net/donate.html

Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys

http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>