Just bolt it in there like any Healey Big six.
You can use your BN4 manifolds, too. Totally worth doing.
Wilko
On Feb 29, 2008, at 4:25 AM, caddi5@comcast.net wrote:
> Gentlemen,
> I need some advice, I have a 1959 BN4 w/original (tired) 26d engine
> and is non-overdrive (still looking for complete trans and overdrive
> unit) I have found a 67 BJ8 engine. The owner of this engine
> said"Head and bottom end are done" he states.. head
> ported,cylinders bored out to next size,new pistons,rods machined
> shot-peened, crank and flywheel balanced,line bored,new bearings,
> cam reground,etc. It needs an exhaust manifold and final assembly.
> My question is what all is required to install this engine into my
> car ,changes,upgrades,benefits,etc.etc. is it worth doing?
> Thanks in advance!
> Mitch
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as wilko2@cox.net
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|