healeys
[Top] [All Lists]

Re: [Healeys] Seats.. (in the BN2, not in the White House)

To: tadeusz.malkiewicz@plusnet.pl, healey.nut@gmail.com, healeys@autox.team.net
Subject: Re: [Healeys] Seats.. (in the BN2, not in the White House)
From: "WILLIAM B LAWRENCE" <ynotink@msn.com>
Date: Tue, 25 Mar 2008 00:37:20 +0000
The foam they are using now is stiffer than the "Dunlopillo" foams that were 
original and are harder to sit on. In order to get a more comfortable feel 
you need to remove some of the foam from the center of the foam to soften 
it., I saw a pattern for drilling the foam with a hole saw to make it more 
compliant. I think it was one of Norman Nock's tips.

Bill Lawrence

>From: Tadeusz Malkiewicz <tadeusz.malkiewicz@plusnet.pl>
>To: 'Alan Seigrist' <healey.nut@gmail.com>, healeys@autox.team.net
>Subject: Re: [Healeys] Seats.. (in the BN2, not in the White House)
>Date: Sun, 23 Mar 2008 23:53:23 +0100
>
>Hmm.. I am over 6ft.. I am roughly 190cm, but on top, I have short legs..
>:-)
>
>
>Thanks for the tip
>
>Cheers, Tadek
>
>
>-----Original Message-----
>From: Alan Seigrist [mailto:healey.nut@gmail.com]
>Sent: 23 marca 2008 23:44
>To: Tadeusz Malkiewicz; healeys@autox.team.net
>Subject: Re: [Healeys] Seats.. (in the BN2, not in the White House)
>
>Tadek -
>
>If I recall most Healey guys that do the BN1/BN2 foam take the foam
>for the 6-cyl cars and trim it to fit.
>
>Also, if you are close to 6 ft tall or more you will need to cut holes
>in the bottom of the foam so you sit low enough in the car.
>
>No patterns are available but if you have the clausager and roger
>moment books you will have enought picures for your trimmer to copy.
>
>Alan
_______________________________________________
Support Team.Net http://www.team.net/donate.html

Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys


http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>