healeys
[Top] [All Lists]

Re: [Healeys] Battery Box rivets for the 100

To: <healeys@autox.team.net>, "William Berg"
Subject: Re: [Healeys] Battery Box rivets for the 100
From: "Rich C" <richchrysler@quickclic.net>
Date: Sun, 13 Apr 2008 12:05:22 -0400
Hi William,

I've taken these dimensions from a low mileage all original BN1 built 
January '54. See below.....

> A. From the left and right side of front lip of the battery box lid, what 
> is
> the distance horizontally to rivets

Answer: From outer edge measuring toward middle, the rivet centres are 
placed at 3" and 3 1/2" in. Same on both sides.

> B.What is the distance between the 2 sets of Rivets in the middle? I 
> believe
> it is 11 inches.

Answer: I don't understand your questions. There are no rivets in the 
middle.

> C. What is the distance vertically from the rivets  to the studs of the 
> rear
> wall?

Answer: Depending on how neatly the wrap over Amacord surround and vinyl on 
lid perimeter, approx. 3 1/4" straight down from middle of two rivets.

> D. If the straps are placed beneath the vinyl cover before they are 
> riveted in
> place, How is the vinyl finished over the strap? Is it folded under and
> notched on the sides? It is supplied as a straight edge on the lip sewn to 
> the
> armacord.

The lid is completely trimmed, then the straps are installed on the inside 
surface of the front lip. Therefore the straps will be fitted against the 
vinyl that wrapped under the lip and glued inside.
Pictures are att'd that may help. All trim is original and undisturbed 
except the new straps to replace the broken originals.

Rich Chrysler

[demime 1.01d removed an attachment of type image/jpeg which had a name of 
dendecker BN1 002.jpg]

[demime 1.01d removed an attachment of type image/jpeg which had a name of 
dendecker BN1 001.jpg]
_______________________________________________
Support Team.Net http://www.team.net/donate.html

Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys


http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>