John, Some people have suggested to have the welding done first then get
the blasting done. I guess this is so the welder can see exactly how the
parts go together
in the areas where some panels may be completely blown away cause of so much
rust. If the rust is just on the surface then I suppose any routine is OK.
Just passing it forward,
Mark
----- Original Message -----
From: "john spaur" <jmsdarch@sbcglobal.net>
To: "Mark and Kathy" <mgtrcars@galaxyinternet.net>
Sent: Thursday, April 17, 2008 10:27 PM
Subject: Re: [Healeys] Frame and Chassis Support
> Hi Mark,
>
> I still have a long way to go, I am just prepping it to be media blasted
> then there is the rust to repair. The axle deal is just while I clean the
> mastic off of the shroud. I would not lash on the kings pins. Sounds like
> you had quite a fiasco.
>
> Please send the jpg.
>
> Thank you,
> John
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|