Any good general-purpose grease should work. I like "moly" (molybdenum-based)
grease.
Bearing grease would probably be too thick to get through the zerks (think
that's Polish for "nipple" ;)
bs
--
***************************************************************
Bob Spidell San Jose, CA bspidell@comcast.net
'67 Austin-Healey 3000 '56 Austin-Healey 100M
***************************************************************
-------------- Original message ----------------------
From: Tadeusz Malkiewicz <tadeusz.malkiewicz@plusnet.pl>
> Hello,
>
> A quick question - what sort of grease should be used for king pins? Bearing
> grease? Or other?,
>
> Thanks, Tadek
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as bspidell@comcast.net
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|