The throw out arm for my 5 speed conversion is too short to line up with the
slave clutch cylinder. I have two of the throw out arms, both from Supra
models. Has anyone else seen this problem, and how did you solve it? Or
perhaps is the truck throw out arm longer? If you happen to have one around,
the measurement form the pivot ball indentation to the slave rod indentation
is 4 and 3\8 inches.
Thank you
Jerry
Bn4
Bj8
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|