healeys
[Top] [All Lists]

Re: [Healeys] 6 hour oil change

To: "Bob Johnson" <robert.w.johnson@charter.net>, "Healeys"
Subject: Re: [Healeys] 6 hour oil change
From: "Rich C" <richchrysler@quickclic.net>
Date: Sun, 3 Aug 2008 09:31:00 -0400
Bob,

It is a simple matter of undoing the two bolts between the filter housing 
assembly and the block. There is only a simple flat gasket (available 
separately Moss #021-115) to replace and realign there. Take the entire 
assembly to the benck and dismantle it into a suitable sized catch pan. Once 
clean, I mount the housing head gently into a bench vise, and using an old 
dental pick, remove the old sealing ring from its groove. There is always a 
new sealing ring in the box with a new filter. Wet the new ring with engine 
oil and install it into the groove. Sometimes a blunt flat bladed 
screwdriver is needed to seat the ring squarely into the groove. Now with 
the new filter and associated spring and backing plate in place, install the 
centre bolt and run it up until the cannister flange seats evenly all around 
the groove. Tighten securely. Reinstall the complete assembly back onto the 
flat gasket at the block, making sure this gasket is in good condition. 
Tighten the two bolts to the block and you're finished.

Bottom line is, get the assembly over to the bench where you can see what 
you're doing to seat that ring properly.

Rich Chrysler

> So yesterday I got around to doing my oil change. > Questions:
> Did I miss some obvious step here?
> Is there an o-ring that will fit? If so, what size do I need to look for?
> These spin-on adapters (really considering this now), is there one that 
> mounts
> the filter in an upright attitude? If so who has it?
>
> Bob Johnson
> BJ8
_______________________________________________
Support Team.Net http://www.team.net/donate.html

Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys


http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>