healeys
[Top] [All Lists]

Re: [Healeys] SU HD8 question

To: "Eric (Rick) Wilkins" <e-wilkins@cox.net>, "Healey List Emails"
Subject: Re: [Healeys] SU HD8 question
From: "Freese, Ken" <Kendall.Freese@Aerojet.com>
Date: Thu, 7 Aug 2008 16:01:28 -0700
If there is a one to one ratio on the jet arm, yes. Is there?
Ken

-----Original Message-----
From: healeys-bounces+ken.freese=aerojet.com@autox.team.net
[mailto:healeys-bounces+ken.freese=aerojet.com@autox.team.net] On Behalf
Of Eric (Rick) Wilkins
Sent: Thursday, August 07, 2008 3:29 PM
To: Healey List Emails
Subject: Re: [Healeys] SU HD8 question

If we know the thread count, we could prolly figger it out, eh?

Wilko

On Aug 7, 2008, at 3:17 PM, Freese, Ken wrote:

> The nominal setting for the jet position is 2 1/4 adjusting screw
> turns from a flush jet position. I need to know what this equates to
> in inches. .050 or .086 or what?? I think I read .086 in a book
> somewhere, but I can't find it now.
> Thanks,
> Ken Freese
> 65 BJ8
> _______________________________________________
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys

You are subscribed as ken.freese@aerojet.com

http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html

Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys


http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>