healeys
[Top] [All Lists]

Re: [Healeys] overdrive

To: "'Mark LaPierre'" <lapierrem@sbcglobal.net>, "'Michael Salter'"
Subject: Re: [Healeys] overdrive
From: "Al Fuller" <al@bighealey.org>
Date: Mon, 18 Aug 2008 19:07:06 -0400
Isn't there a whole section on overdrive trouble diagnosis in the manual??
Al

Al Fuller
Fuller Compliance, LLC

Quality Systems Consulting
Software Quality, Validation + 21 CFR Part  11

714.335.0248
 www.fullercompliance.com



-----Original Message-----
From: healeys-bounces+al=bighealey.org@autox.team.net
[mailto:healeys-bounces+al=bighealey.org@autox.team.net] On Behalf Of Mark
LaPierre
Sent: Sunday, August 17, 2008 7:09 AM
To: Michael Salter; 'edwardkiessling'; healeys@autox.team.net
Subject: Re: [Healeys] overdrive

Come on,  there has to be a simpler test than this.

This is enough to make someone want to sell there Healey just to by pass the
hassle.

Mark


----- Original Message -----
From: "Michael Salter" <msalter@precisionsportscar.com>
To: "'edward kiessling'" <ekiessling@sbcglobal.net>;
<healeys@autox.team.net>
Sent: Saturday, August 16, 2008 10:21 AM
Subject: Re: [Healeys] overdrive


> Hi Ted & Les,
> You need to determine if the failure to disengage is caused by the
> overdrive's hydraulic system retaining pressure or if the problem is
> mechanical.
> The easiest way is to, remove the gearbox tunnel, get the rear wheels off
> the ground, "drive" the car until the "locked in overdrive" condition is
> achieved (engine stopped), then remove the operating valve plug to see if
> there is residual oil pressure. If, once the pressure is relieved the
> overdrive becomes disengaged the most likely problem is the "bleed off"
> hole
> in the side of the operating valve.
> Michael Salter
>
> -----Original Message-----
> From: healeys-bounces+msalter=precisionsportscar.com@autox.team.net
> [mailto:healeys-bounces+msalter=precisionsportscar.com@autox.team.net] On
> Behalf Of edward kiessling
> Sent: Saturday, August 16, 2008 10:08 AM
> To: healeys@autox.team.net
> Subject: [Healeys] overdrive
>
> Need help ----Bt7 overdrive refusing to disengage-has been rebuilt.
>
>  thanks Ted& Les
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as msalter@precisionsportscar.com
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html

Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys


http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>