Team.
Jetnuts are a nice bit of kit and a recommended application would be to use
them on the lower four studs that hold the carbs to the inlet manifold. They
allow a smaller spanner or even a socket to be used underneath those HD8's.
It make s a big difference, especially for you LHD guys where the steering
column adds to the problems.
First recommended on this list a couple of years ago.
I wouldn't use them, or any steel nut, anywhere on the exhaust side -
guaranteed to weld themselves solid.
_______________________________________________
(______________ Alan Bromfield _______________)
(______ \__1957-BN4 x 2__/ _______)
(______www.nfahc.co.uk____)
-----Original Message-----
From: healeys-bounces+alan.bromfield=virgin.net@autox.team.net
[mailto:healeys-bounces+alan.bromfield=virgin.net@autox.team.net] On Behalf
Of Bob Spidell
Sent: Sunday, August 24, 2008 11:35 PM
Cc: Healey List
Subject: Re: [Healeys] Intake Nuts
Anybody tried these on the exhaust manifold to downpipe flange studs?
bs
John Sims wrote:
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|