Contact Doug Reid for correct, pre-formed brake and fuel lines. The last
email address I have for him is spannerman@earthlink.net . Also,
spannerman@prodigy.net might work.
John Snyder
----- Original Message -----
From: <stella67@aol.com>
To: <healeys@autox.team.net>
Sent: Saturday, September 13, 2008 9:40 AM
Subject: [Healeys] hydrolic and battery cable sources
>I am restoring a BN7 MK II and starting to assemble some of the critical
>parts? The body and frame are finally about ready, the engine and trans are
>done and the reassembly will start soon.? In looking through the parts I
>stored over the last seven years.? Having restored five Healeys I should
>have known better but I did not keep track of my parts well.?Over the years
>I have misplaced some critical parts. I can not find the battery cables for
>the BN7 and the brake/ petrol lines.? This means I have none of the
>original connectors or patterns for them. Since I am putting this together
>"as original" I need a source of lines or the fittings and patterns of the
>pieces needed.?I searched the archives but did not find?a source.? I may
>have missed it because there was a?lot of information on hydraulics and
>batteries. ?I would appreciate information on a source for the lines or the
>parts to make the lines.?The last time I ordered?new hydraulic?lines the
>came as rolled up copper lines
> which is not what I want. I ordered some "original battery" cables and
> they are incomplete and no where near correct.? I contacted British Wiring
> and they don't make them?but will provide the parts - but without a?good
> pattern that won't work.? Any suggestions - I know don't?toss parts before
> you know what your are doing - would be appreciated.????Thanks John
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|