What about the 4 cylinder engine? What mods can it take?
Mike MacLean
56 BN2
60 AN5
On Sat, Feb 7, 2009 at 9:51 AM, Oudesluys <coudesluijs@chello.nl> wrote:
> Triple Dell'Orto's/Webers 40/45 mm, venturi's around 35/38, larger SS
> valves, porting and balancing of the head, free flow exhaust, electronic
> ignition to start with.
> If you have to build up the engine from scratch, have the crank ground on
> very tight tolerances in all bearings, have it tuftrided, polished and
> balanced, balance and polish the piston rods increase oil pressure by using
> a high volume pump if that is available or rebuild and use shims under the
> relief valve spring. Use an electric oil pump to prime the system before
> starting up. Use an oil cooler with thermostat.
> Lighten the flywheel a little for a bit more accelleration allthough it
> does not provide extra BHP, do not over do it as you may wreck the gearbox,
> drive shaft and differential because of unsufficiently damped, by mass,
> vibrations.
> Kees Oudesluijs,
> NL
>
> john doe schreef:
>
>> looking to rebuild a 3000 motor but looking to get more hp out of it what
>> are the available options without putting in a cam that would make a rough
>> idle any articles out there _______________________________________________
>> Support Team.Net http://www.team.net/donate.html
>>
>> Healeys@autox.team.net
>> http://autox.team.net/mailman/listinfo/healeys
>>
>> You are subscribed as coudesluijs@chello.nl
>>
>> http://www.team.net/archive
>>
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as rrengineer@dslextreme.com
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|