Hi Keith,
The sliding driver's seat began in Dec. '53 at car 149950 along with the
introduction of non adjustable steering column. Your 152199 would have this
arrangement, with the passenger's seat still on 5/8" wood packer strips on
top of the 1/4" strips to equalize the seat heights. Your passenger's seat
would have two sets of bolt hole adjustments in the metal seat pan.
Rich Chrysler
AHCA Hundred Registrar
----- Original Message -----
From: "Keith Bailey" <keithbailey5@bigpond.com>
To: <Healeys@autox.team.net>
Sent: Friday, February 13, 2009 8:34 PM
Subject: [Healeys] Seat Mounts
> Hi All
> Seat mountings for BN1
> I understand the early BN1 had fixed mountings for both seats, then a
> sliding
> mount for drivers seat and latter sliding on both seats at what stage was
> the
> modification carried out my BN1 chassis no is152199 Feb 54
> Regards Keith
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as richchrysler@quickclic.net
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|