Steve,
This piece is available separately. It is die cut out of a vinyl grained
black mill board, with fold seams embossed, etc. so it's not something you'd
"home make". It always comes with the boot lining Armacord kits anyway.
Rich
----- Original Message -----
From: "Stephen Hutchings" <s.hutchings@rogers.com>
To: <healeys@autox.team.net>
Sent: Thursday, April 02, 2009 10:50 AM
Subject: Re: [Healeys] Fasteners securing cardboard fuel filler pipe BJ8 ?
> Actually, while we're on the subject,; does anyone have a pattern for this
> piece? My car is missing the original, so I haven't got anything to use as
> a template.
> Stephen, BJ8
>
>>Hello Folks,
>>
>> This is a niggly point, I know
>>
>>What fasteners arre correct for holding the cardboard panel over the
>>filler
>>pipe in the boot of a late BJ8? The Concourse guidelines say: "secured
>>with
>>chrome Phillips pan head screws". My vendor went me chrome oval head
>>screws
>>with finishing washers for this application. Any originals out there?
>>
>>Thanks
>>
>>Wes Keyes
>>York,Maine
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as richchrysler@quickclic.net
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|