John ... Let the slave cyl, hang down on the hose ...put a bleed hose on the
bleed screw put the other end into a jar . NOW with your friends HAND very
slowly press the pedal down 3 or 4 times till no air is coming out the hose
... NOW push the slave cyl. piston back into it's body and tighten bleed screw
... KEEP A CHECK ON THE FLUID IN THE RESERVOIR... bolt the cyl. in place and
pump up the clutch pedal till it feels right Norman Nock
PS tell me if you did it this way
TECH TALK by Norman Nock
l have been writing technical articles
for Healey
clubs for over 25 years .
After numerous requests , l have
gathered them
together, along with
some never before published
articles and had them spiral
bound in book form
$ 35.00 + $7.50 in USA
265 pages Updated
Annually
Both our catalogs are on line and can be down loaded
www.BritishCarSpecialists.com
209 948 8767
Tech Talk
SAMPLE PAGES ON LINE
British Car Specialists
2060 N Wilson Way
Stockton CA 95205
--- On Sun, 4/5/09, STOCKLAND@aol.com <STOCKLAND@aol.com>
wrote:
From: STOCKLAND@aol.com <STOCKLAND@aol.com>
Subject: [Healeys] BJ 8 Clutch Question
To: healeys@autox.team.net
Date: Sunday, April 5, 2009, 9:11 AM
Just replaced the flexible hose to the clutch slave cylinder and now I need
to bleed the system. However, I cannot get to the bleed screw. Is there
some technique I am missing? Thanks for your suggestions.
Jon
**************Feeling the pinch at the grocery store? Make dinner for $10 or
less. (http://food.aol.com/frugal-feasts?ncid=emlcntusfood00000001)
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
You are subscribed as sjnnock@sbcglobal.net
http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|