I used bicycle inner tubes and some black silicone sealant on both
sides to set it in the channel. After cutting away the excess she
looks like a factory installation.
On 5/10/09, Herbert Miller <hgmiller3@qwest.net> wrote:
> I am replacing the side window glass in my BJ8. What is used to secure the
> window frames to the glass? The archives yields posts referring to a rubber
> seal that is installed into the channel, then the glass and then oil is
> applied to expand the rubber. Other posts say this does not work and Moss no
> longer sells the seal. What is a guy to do?
>
> Herb Miller
> 1967 BJ8 Phase II
> 1962 BT7 MK II Tricarb
> 1960 AN5
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as healey.nut@gmail.com
>
> http://www.team.net/archive
>
--
Sent from my mobile device
Alan
'52 A90
'53 BN1
'64 BJ8
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|