Yup, thought I had overfilled my BN7 then discovered the tube was missing.
Norm Nock fixed us up, "drove it in" (no threads) and problem solved. Quarts
equaled what the manual stated.
Richard of KY
BN7 #440
------Original Message------
From: John Snyder
To: jmnewt@comcast.net
To: healeys@autox.team.net
Subject: Re: [Healeys] Dip Stick Tube
Sent: May 20, 2009 21:16
The tube for the dip stick is not screwed in. It is pressed in. Just pick
drill bit that is a snug fit inside the tube. Push it in, grip the tube w/
a vice-grip pliers, and whack the pliers w/ a hammer. The tube will pop
right out. At least this is true for 3000 engines.
John Snyder
> Anyone know what thread size and count is on the small tube which guides
> the
> dipstick into the block. During a recent engine rebuild I discovered
> some
> pretty mangled threads on mine to the extent that I can't get a good
> count.
> TIA, Jack
_______________________________________________
Support Team.Net http://www.team.net/donate.html
<http://www.team.net/donate.html>
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
<http://autox.team.net/mailman/listinfo/healeys>
You are subscribed as gonnagitcha90@hotmail.com
http://www.team.net/archive <http://www.team.net/archive>
Sent from my Verizon Wireless BlackBerry
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|