healeys
[Top] [All Lists]

Re: [Healeys] rear wheel stud

To: "Simon & Christine Atkinson" <satkinson7314@charter.net>
Subject: Re: [Healeys] rear wheel stud
From: Alan Seigrist <healey.nut@gmail.com>
Date: Tue, 16 Jun 2009 09:53:42 +0800
Simon -

Taking the hub off the car is typically a pretty easy thing to do.  Just
remove the axle (comes right out), and then unscrew the octagon then either
use a puller or hand pull the hub off the axle.

Then use a vise and press the stud out.  Putting a new stud in is a bit
difficult, I think the best I've heard is freeze the bolts and put the hub
in the oven at top setting thenpress together using a vice and alot of heat
pads!

Cheers,

Alan

'52 A90
'53 BN1
'64 BJ8


On Tue, Jun 16, 2009 at 9:07 AM, Simon & Christine Atkinson <
satkinson7314@charter.net> wrote:

> Appears that I have a rear wheel stud that needs to be replaced. Of course
> I
> just noticed it after installing all the new brake hardware!
>
> Any easy way of replacing this without tearing everything apart? Do I have
> to remove the spacer and bearings?
>
> I wish the engineers would have put a hole in the backplate so you could
> just line up the stud to the hole and bang it out (with a grommet for water
> protection).
>
>
>
> Thanks,
>
>
>
> Simon
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as healey.nut@gmail.com
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html

Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys


http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>