Yes, if you can get under the car, it is very easy to take it off. Note the
position of the two slightly different screws on the carb side of the engine
that take the little clips for the float bowl overflow pipes, so that you
can get them back in the right position.
Whether the dents can be easily beat out depends on where they are - that
bit is your call
Mirek
----- Original Message -----
From: "I Erbs" <eyera3@gmail.com>
To: "HealeyRick" <healeyrick@yahoo.com>
Cc: <healeys@autox.team.net>
Sent: Sunday, June 21, 2009 7:22 PM
Subject: [Healeys] dented oil pan
> Hello,
> Unlike most of you :)
> my oil pan is dented. Its been many years since I looked inside of one.Can
> I
> remove it with the engine in place and beat the dents back down?
> If not..
> <Bill Bolton do you have a dent free unit for my MKI 3000.
> I'll drive down if the price is right:)>
> Or anyone in the oregon/washington area
>
>
>
> --
> I Erbs
> Portland, OR
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as m.g.sharp@sympatico.ca
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|