No, you do not need to take it apart. Just put some dish washer soap in the
rubber groove and thread it in through one of the slots in the shroud. Not
easy, just take your time. Put some masking tape around the exterior of the
opening in the shroud.
John Snyder
>I know I read about this a couple years ago but can't find it in the
>archival
> replays.
> Sooo, is it necessary to take a new rear BT7 reflector unit apart to
> install
> the rubber grommet,
> and then reassemble it on the car. Or does one have to wrestle the
> reflector into position as a set.
>
> I don't want to learn the hard way with a scratched paint job.
>
> Thanks, Mark
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|