John,
What series Healey?
Rich Chrysler
----- Original Message -----
From: "john spaur" <jmsdarch@sbcglobal.net>
To: <healeys@autox.team.net>
Sent: Sunday, July 26, 2009 1:07 AM
Subject: [Healeys] A-pillar face plate
>I need to remove and replace the A-pillar face plate; just the upper
>portion.
>
> The replacement part tucks up under the inner scuttle top panel. What
> should I do to bend the scuttle flange up then back down again? I think I
> need to heat it, but I am not sure of the heating and cooling process so
> as to not damage the metal.
>
> I check the archives and around the Internet but did not find what I
> needed.
>
> Help from the list would be very much appreciated.
>
> Thank you,
> John
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as richchrysler@quickclic.net
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|