I believe all the available side spears are from the same source. It's not
difficult to fit them. A couple of the studs are reachable from inside the
engine bay to inside the fender. Lying flat on your back, you can reach
straight up to get the others.
Just make sure you put them on right way around. The thicker part goes to
the rear.
Rich Chrysler
----- Original Message -----
From: "Mark LaPierre" <lapierrem@sbcglobal.net>
To: <healeys@Autox.Team.Net>
Sent: Friday, July 31, 2009 12:01 PM
Subject: [Healeys] Fender emblem advise
> Any input on where to buy new fender side chrome emblems for the big
> healeys
> would be appreciated. Quality is my main concern. I have my old ones
> but
> they need a rechrome.
> How are the Moss units?
>
> Also I prefer not to remove my lower fenders to install these emblems, any
> success stories
> on after market adhesives that have worked or even the 2 sided emblem tape
> that 3M sells
> maybe.
>
> Comments appreciated, Mark
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as richchrysler@quickclic.net
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|