Mark,
The grille piece fits from the inside. There are small notches in the bottom
corners that should allow the bottom edge to sit ahead of the bottom lip of
the bonnet. Of course this is one area that really must be trial fitted
before paint.
Rich Chrysler
----- Original Message -----
From: "Mark LaPierre" <lapierrem@sbcglobal.net>
To: <healeys@Autox.Team.Net>
Sent: Monday, September 07, 2009 12:57 PM
Subject: [Healeys] Install Sequence Needed
> This should be an easy one for most of you.
>
> Does the small Air Intake grille on the front of the hood install on the
> outside or the inside of
> the hood. It seems to line up better from the inside but it cuts off the
> bottom slat of the
> grille. The top grille piece fits perfectly on the outside but the
> grille
> itself does not, but seems
> to fit better from the inside , but still not perfectly.
>
> I have the packing material that goes under the top grille piece.
>
> I cannot find a close up picture of the hood that shows this area in
> detail.
>
> Thanks, Mark
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as richchrysler@quickclic.net
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|