healeys
[Top] [All Lists]

Re: [Healeys] BN2 rear axle

To: "John Harper" <ah@jharper.demon.co.uk>, <healeys@autox.team.net>
Subject: Re: [Healeys] BN2 rear axle
From: "Thomas Willig" <twillig@ruda.de>
Date: Fri, 18 Sep 2009 09:27:28 +0200
John,

they are replacements bought from A-H Spares a couple of years ago. would be
interesting to get the length of the original bolts.

Best regards


Thomas


-----Urspr|ngliche Nachricht-----
Von: John Harper [mailto:ah@jharper.demon.co.uk]
Gesendet: Freitag, 18. September 2009 09:01
An: Thomas Willig; healeys@autox.team.net
Betreff: Re: [Healeys] BN2 rear axle


Thomas

I seem to recall that one of the parts suppliers were selling the more
readily available MG U bolts that were longer but could be cut down to
the correct A-H length.

Are your U bolts original or are they replacement?

Regards

>
>I would not be cutting those U bolts down any shorter or you'll never
>get them back on a second time should you ever need to. Also have you
>made sure you have installed everything that should be there including
>the red fibre spacer?
>
>Rich Chrysler
>
>----- Original Message ----- From: "Thomas Willig" <twillig@ruda.de>
>To: <healeys@autox.team.net>
>Sent: Thursday, September 17, 2009 3:31 AM
>Subject: [Healeys] BN2 rear axle
>
>
>> After fitting the rear axle to my BN2, I found out that the threaded
>> ends of the u-bolts protrude from the spring plate by over an 1". I
>> think that this is a lot and it looks like there might be a chance that
>> something could get caught  in it.
>>
>> I am aware that the u-bolts have to be that long for the fitting of the
>> axle, but I wonder if the u-bolts have to be cut down after the axle has
>> been fitted?
>>
>>
>>
>> Thomas Willig

--
John Harper
_______________________________________________
Support Team.Net http://www.team.net/donate.html

Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys


http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>