healeys
[Top] [All Lists]

Re: [Healeys] Fw: Temp gauge Reading

To: donham <donham1@cox.net>, Healeys <healeys@autox.team.net>
Subject: Re: [Healeys] Fw: Temp gauge Reading
From: Alan Seigrist <healey.nut@gmail.com>
Date: Mon, 19 Oct 2009 22:53:39 +0800
You likely have worn throttle shaft/bushings, which when the carb gets
hot they start allowing too much air into the carb, leaning out the
idle mixture, causing it to stall.  The only solution here is to have
your carbs professionally rebuilt.  Sometimes just replacing the
throttle shafts is good enough if you are lucky.

Alan

On 10/19/09, donham <donham1@cox.net> wrote:
> ----- Original Message -----
> From: donham
> Sent: Sunday, October 18, 2009 2:25 PM
> Subject: Fw: Temp gauge Reading
>
>
> Need advice on my problem. When the outside temp is between 80-90 degrees my
> BJ7 wants to stall after stop and go traffic when the temp gauge reaches
> 190-200. Today with the outside temp in the 69-72 range I had no problem.
> Tempo gauge stayed at 160-170.
> Any help is appreciated.
> DH
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as healey.nut@gmail.com
>
> http://www.team.net/archive
>


-- 
Alan

'52 A90
'53 BN1
'59 Jag Mk IX
'64 BJ8
_______________________________________________
Support Team.Net http://www.team.net/donate.html

Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys


http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>