I have done the same. Another thing I do is to put a little fine valve
grinding compound on the plunger, put it into the valve assembly and rotate.
This will give a very nice smooth surface. Clean and reassemble.
Herb Miller
-----Original Message-----
From: healeys-bounces@autox.team.net [mailto:healeys-bounces@autox.team.net]
On Behalf Of Steve Gerow
Sent: Saturday, November 14, 2009 6:19 PM
To: healeys@autox.team.net
Subject: [Healeys] Heater Tap Handle [was 'Brass']
Mirek Sharp wrote:
>I think the "handle" part of the tap is actually threaded into the "ball".
>Perhaps with some heat and coaxing you can get the broken bit out and save
re-tapping it.
I took mine apart - it indeed had a small threaded hole - either a 6-32 or
8-32, I forget which.
I drilled it out with the appropriate drill and tapped it to 10-32 and made
a new handle from part of a long 10-32 stainless socket head screw, cut to
the appropriate length. The steel is strong enough to turn without bending.
--
Steve Gerow
Pasadena, CA, USA
BN6
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
You are subscribed as hgmiller3@qwest.net
http://www.team.net/archive
No virus found in this incoming message.
Checked by AVG - www.avg.com
Version: 8.5.425 / Virus Database: 270.14.65/2502 - Release Date: 11/14/09
07:43:00
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|